Table of Contents

Reporting a problem (Sending a Log file)

You can report an Issue directly from PowerScripts, this will also send the log files to help solve your problem. Choose it from the panel menu (top right corner of the PowerScripts panel)


MRAP and PARM Errors

Under the hood, PowerScripts runs on Illustrator's built-in scripting engine. The MRAP and PARM errors occur when PowerScripts asks Illustrator for information and Illustrator encounters an unknown error, This can be due to:

Step 1: Verify it is a problem with PowerScripts or Illustrator

If your result is:

Step 2: Determine if the error is a Setting or Artwork

If you restarted illustrator in step 1 and the error still exists then:

  1. Open the panel menu in the top right corner of the panel
  2. Choose “Reset options to factory defaults”
  3. Run the PowerScript

If your result is:

  1. If the error goes away, one of the settings was causing a problem. Carefully change your settings one by one and test the script to see if you can reproduce the error. If you find a particular setting is causing the problem, Send an error report (as detailed at the top of this page) with a description of the error.
  2. If you still have an error then go to Step 3

Step 3: Sending artwork to us to inspect

If you have confirmed your custom settings are not the problem, then its most likely an issue with the artwork, you will need to isolate the artwork causing the issue and email us the artwork so we can reproduce the error

Once we receive the file, we can test it and see if we can reproduce the error here, If we can we will work on a fix or patch to eliminate the issue.

A new PowerScripts version causes problems

Open the panel menu (top right corner of the PowerScripts panel) and choose Choose PowerScripts Version…. Pick the earlier version you were using and start it - earlier versions stay installed, so you can keep working. Then report the issue as described above so we can fix it.

Sending the PowerScripts Log Files Manually

If you are unable to run the program or report an issue, you will need to manually send us the log files: powerScripts.3.8.40.log (the number is your PowerScripts version; older versions write powerScripts.log), powerScriptsLoader.log and powerScriptsStart.log

To send the log file

macOS

Windows